Installing 1 Lb. Disposable Cylinder - Coleman 9928 Série Manuel D'installation

13. After cleaning or inspection,
return the burners down to the
proper position. Check that all
the burner venturi are set over
the valve outlets correctly. The
valve orifices must be inside the
venturi tubes and the venturi
tubes must be inside the burner
tubes (Fig. 15). Reinstall the
burner screws.
14. Before lighting the grill, reassemble and make sure all parts are in
their proper working position.
Installing 1 lb. Disposable Cylinders
NOTE: Your 9928 Series grill is set up from the
factory to use a 1 lb. disposable
propane cylinder.
WARNING
Only cylinders marked "Propane" must be used.
WARNING
This procedure MUST be performed OUTDOORS only!
Read and follow the directions on the cylinder.
DANGER
• NEVER store a spare L.P. gas supply cylinder under the
grill body or inside the grill enclosure or in the vicinity of
any heat producing appliance.
Failure to follow this information exactly could result in an
explosion and/or fire causing death or serious injury.
CAUTION
Tighten by hand only. DO NOT use tools.
1. Screw the regulator into the grill hand tight (Fig. 16).
Fig. 16
Fig. 15
Burner Tube
Venturi
Tube
2. Open the grill lid and extend the side tables. Lower the
propane bottle support (Fig. 17).
Fig. 17
Propane
Bottle
Support
3. Remove the plastic cap from the propane bottle and screw the
propane bottle into the regulator hand tight (Fig. 18).
Fig. 18
4. The cylinder must be arranged for vapor withdrawal. Illustration
(Fig. 19) shows the propane bottle properly installed.
Fig. 19
English-7