Grill Assembly - Coleman 9928 Série Manuel D'installation

IMPORTANT: Remove all packing material prior to assembly/use. If your grill has stainless steel components,
remove all protective plastic film from stainless steel parts prior to assembly/use. This film is installed at the
factory to prevent damage that could occur during shipment and handling.
Assemble the Towing Handle
1. Place the grill on a flat and level surface. Insert the towing handle into
the rectangle tubing in the stand (Fig. 3).
Fig. 3
Locking
Button
2. Depress the locking buttons at the same time, then slide the
towing handle until it locks in place (Fig. 4).
Fig. 4
Extend the Grill Support
3. Make sure the Towing Handle is extended and locked in position
(Fig. 3).
4. Place one foot on the Towing Handle, grasp the lift handle and lift to
extend the grill stand (Fig. 5).
Fig. 5

Grill Assembly

5. Continue to lift the grill until the stand extends past the locking bracket
(Fig. 6).
Fig. 6
Locking
Button
6. Carefully lower the grill into the grill stand, making sure the unit is
secured in the upright position (Fig. 7).
Fig. 7
7. The locking bracket must engage the stand (Fig. 8).
Fig. 8
English-5
Locking
Bracket