Domo DO9199KR Mode D'emploi page 29

7. To remove the vegetable slicer: Press the unlock button (see diagram) and turn the vegetable slicer
clockwise a quarter turn.
8. Remove the vegetable slicer and replace the lid onto the connection.
9. Clean and dry all parts thoroughly prior to using them again.
LCD DISPLAY
Timer
1. Place the desired accessory.
2. With the buttons – and +, you can set the timer to a maximum of 10 minutes.
· With the time setting up to 5 minutes, you can increase (+) or decrease (-) the time by 30 seconds.
· With the time setting higher than 5 minutes, you can increase (+) or decrease (-) the time by 1
minute.
3. Press "OK" when the desired time is set.
4. Turn the speed control knob to the desired position.
5. The timer counts down. When it reaches 00:00, the appliance will switch off automatically. The LCD
screen will flash for 3 seconds and you will hear an acoustic signal.
Speed indication
The selected speed will appear on the display.
Aanduiding belasting
De streepjes op de het display geven de belasting van het toestel weer. Als het toestel overbelast wordt,
zal de verlichting van de snelheidsregeling rood kleuren en hoor je een signaal. Schakel het toestel uit.
Zorg voor een minder grote belasting (minder ingrediënten) voor het toestel opnieuw te gebruiken.
Load indication
The markings on the display show the load of the appliance. If the appliance is overloaded, the indication
light of the speed button will turn red and you will hear a signal. Switch off the appliance. Make sure that
you use a smaller load (fewer ingredients) before using the appliance again.
Error code
If the error code E03 appears on the display, the multifunctional head is not positioned correctly or the lid
for the connection point of the blender is not installed.
www.domo-elektro.be
29
DO9199KR