SCHOLTES LTE S3 XL60HZ Instructions Pour L'installation page 14

Use the screwdriver to secure the door hooks with the 8
EN
supplied screws (see fig. 5-20) at the marked reference
points.
Fig. 5-20
Drill holes for the panel handle using a drill with a
suitable bit. Use the screwdriver to secure the door
handle before hooking the panel to the dishwasher (see
fig. 5-21).
N.B.: the screws are not supplied.
Fig. 5-21
Attach the door panel: fit the hooks into their slots on the
dishwasher and allow the panel to slide downwards and
slip in to place (see fig. 5-22).
Fig. 5-22
Secure the door to the panel with the supplied screws.
The panel must have a minimum thickness of 20 mm (25/
32") (see fig. 5-23).
14
Fig. 5-23
Make sure the dishwasher door, complete with panel,
opens comfortably and that the base plate (ref. A fig. 5-
24) does not prevent it from opening fully. If the base plate
prevents the door from opening, mark out the section to
remove (see fig. 5-24), take out the base plate and cut it
along the marking using a compass saw (see fig. 5-25).
Fig. 5-24
Fig. 5-25
5.3.3 Completion of installation (all models)
Finish the cut with a file (see fig. 5-34) in order to remove
any burrs and/or imperfections. Put back the base plate
(see fig. 5-35) and try to open the dishwasher door fully;
if the base plate still obstructs the door, repeat the above
operations.