Specification; Dimensions And Connections - Stiebel Eltron DHC 3 Utilisation Et Installation

INSTALLATION

Specification

Adjusting the flow rate
If the required temperature is not achieved, you can limit the flow
rate. This will give you a higher temperature.
f Set the flow rate with the adjusting screw in such a way that f
the outlet temperature complies with the details in chapter
"Specification / Data table".
Clean sieve
You can clean the fitted sieve after removing the cold water con-
nection pipe.
1. 90°
2.
1 Earth screw
2 Strainer
3 Cold water connection pipe
f Undo the earth screw by approx. two turns. f
f Loosen the cold water connection pipe by turning the pipe f
in the differential pressure switch through 90° and pulling it
down.
f Clean the strainer and replace if required. f
f Reinstall the parts in reverse order. f
Material damage
!
Always secure the earth screw.
24 | DHC
Activating the high limit safety cut-out
Once faults have been remedied, you can reactivate the high limit
safety cut-out.
f Isolate the appliance from the power supply and depressur- f
ise the water line. Push in the high limit safety cut-out reset
button.
Appliance storage
f Store the dismantled appliance in a room free from the risk f
of frost, as water residues remaining inside the appliance can
freeze and cause damage.
15. Specification

15.1 Dimensions and connections

1
DHC 3, DHC 4, DHC 6, DHC 8
2
3
c06 c06
b02 Entry electrical cables 1
c01 Cold water inlet
c06 DHW outlet
b02
54
c01 c01 35
100
200
Male thread
Male thread
www.stiebel-eltron.com
104
G 1/2 A
G 1/2 A