Electrical Connection - Balluff BOS R254K-UUI-LH10-S4 Notice De Montage

BOS R254K-UUI-LH10-S4
Photoelectric Sensors
Display elements
LED 1 (operating status and communication)
Signal Meaning
Static red General error
Green alternating IO-Link communication is active.
with LED off at ratio The device is ready.
of 10:1, 1 s period
Static green The device is ready.
LED 2 (indication/warning/teach/ping)
See document IO-Link configuration under
www.balluff.com on the product page.
Installation
CAUTION
Visible laser radiation
If you look into the laser beam, temporary blinding and
irritation of the eyes is possible. Use of Controls or
adjustment or performance of procedures other than
those specified herein may result in hazardous radiation
exposure.
► Locate sensor so that it is not possible to look into
the laser beam even during operation.
► Observe the instructions in this manual.
The sensor can be fastened with two M4 screws.
Plug outlet direction (example image of use with angled
connector (accessories)):
www.balluff.com

Electrical connection

1
2 4
Plug layout (top view of M12 plug on
3
BOS)
Pin Signal
1 L+ (Operating voltage +, SIO 10...30 V,
IO-Link 18...30 V)
2 I/Q (Digital input / digital output / analog output)
3 L− (Operating voltage −)
4 C/Q (IO-Link communication / digital output in SIO
mode)
Factory setting
– Mode: SIO mode
– Object recognition operating mode: Standard
– PIN 2: Push-pull switching output
– PIN 4: Push-pull switching output
Also see document IO-Link configuration under
www.balluff.com on the product page.
Shielding and cable routing
Cable length
For IO-Link operation, the maximum cable length is 20 m.
english 2