SEVERIN BA-3284 Mode D'emploi page 8

Steam Generator
Dear Customer,
Before using the appliance, the user should
read the following instructions carefully.
Connection to the mains supply
The appliance should only be connected to
an earthed socket installed in accordance
with the regulations. Make sure that the
supply voltage corresponds with the voltage
marked on the rating label. This product
complies with all binding CE labelling
directives.
Familiarisation
1. Rating label (on the steam generator)
2. Power cord with plug
3. Flexible connecting hose
4. Steam generator
5. Temperature indicator light – iron
6. Iron
7. Swivel-type anti-kink covering
8. Handle
9. Water-level warning light
10. Steam output control
11. Main indicator light
12. Steam output
13. Steam output
14. Steam output
15. Anti-scale insert
16. Water reservoir
17. Steam jet button
18. Temperature control knob (infinitely
adjustable)
19. Sole plate
20. Iron stand
Important safety instructions
●
Before the appliance is used, the main
body including the power cord as well as
any attachment fitted should be checked
thoroughly for any defects or leakage.
Should the appliance, for instance, have
been dropped onto a hard surface, it
must no longer be used: even invisible
damage may have adverse effects on the
operational safety of the appliance.
●
The power cord should be regularly
examined for any signs of damage. In the
event of such damage being found, the
appliance must no longer be used.
●
Do not operate the appliance if excessive
strain has been put on the connecting
hose. Damage cannot always be detected
from the outside; the entire unit should
therefore be checked by a qualified
technician before it is used again.
●
Always place the appliance on a flat,
level and heat-resistant surface during
operation. Do not position the appliance
on or near hot surfaces or open flames
such as hot-plates or gas flames.
●
Great care is necessary in using any
electrical appliance, especially near
children. Do not leave the appliance
unattended while connected. Always
remove the plug from the wall socket and
place the iron back on its stand on the
steam generator.
●
When ironing is interrupted, the
appliance must be replaced on its stand
on the steam generator. The iron can also
stand on its rear end.
●
The appliance operates at very high
temperatures. Do not touch any part of
the appliance except the handle. Burns
can occur from touching the hot parts of
the housing or the sole plate and from
hot water or steam. Do not allow steam
to escape in the direction of anyone
nearby.
●
When operating the appliance, hold only
by the handle.
●
Do not attempt to iron or to smooth out
wrinkles or creases from clothes by using
the steam jet function while wearing
them.
●
Caution: The connecting hose may reach
high temperatures during operation.
●
Do not allow the power cord to touch
hot surfaces. Do not coil the power cord
round the appliance.
●
Always remove the plug from the wall
6