Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating manual
pneuMATO 55 Lube-Jet
1
Safety instructions:
1
1)
Attention! Read operating manual before use.
2)
Warning! Wear ear protectors during use.
3)
Warning! Wear gloves during use.
4)
Warning! Danger from spraying grease, use safety glasses.
5)
Take note, e.g. never point greasing hose at people or animals
6)
Environmentally friendly disposal
Failure to comply with the safety instructions may result in the endangering of people as well
as the environment and the facility. Failure to comply with the safety instructions may lead to
loss of any claims for damages. The operator of the facility must ensure that the contents of
the manual, especially the safety instructions for the operators, are known.
General information
Protect device from damage and the effect of strong heat.
−
In order to prevent grease spilling onto the floor do not use grease pump in the rain.
−
Never point the lubricating gun at people or animals! Risk of injury!
Instructions for preliminary actions / handling
Observe safety data sheets for hazardous substances (grease) used.
−
Protective gloves made of leather and goggles must be worn during use.
−
Do not bend high pressure hose sharply.
−
Instructions for repair / maintenance
For the operation of pneumatic pumps, the fitting of a pressurised air maintenance unit (Order
−
No. 39 902 20) is absolutely recommended.
Regularly check the pressure-bearing components (pressure hose and lubricating gun) of the
−
pump for damage.
Pressurised air and hydraulic hoses are to be changed by the manufacturer.
−
Use of non-original accessories, e.g. hose lines and connecting nipples, can in isolated cases
−
pose the risk of accidents. In case of accidents or damage caused by foreign parts liability cannot
be accepted.
Modification or alteration of the device is only permitted after consultation with the manufacturer.
−
The reliability of the device is only guaranteed when used as intended.
−
Maintenance, inspection and repair work must only be performed by qualified personnel.
−
Carry out repair and maintenance work in unpressurised conditions only.
−
Never place items on a dirty surface when changing the grease container pump and grease
sequence cover. Contaminants entering the lubrication system can cause damage to machinery
bearings as well as to the pneumatic grease pump.
Caution: hot components cool only gradually after being switched off, cold components only heat
−
up slowly.
/ Benzstr. 16-24 / 63165 Mühlheim a. Main / Tel:+49(0)6108-906-0 / Fax:+49(0)6108-906-120
GmbH & Co. KG
MATO
3
2
4
5
6
9
Publicité
Table des Matières
