USING THE EXTRACTOR FAN
Switch-on
ON/OFF button of hob/extractor fan
Push (tap)
The indicator light will turn on to indicate that the hob/extractor
is ready for use
Press again to turn off
Note: This function has priority over the others.
Starting the extractor:
Tap (push) the Selection area (6) to enable the hob
Extraction speed (power):
The hob features 8 suction power levels
Tap and swipe with your fingers onto the Selection zone (3):
to the right to increase the suction speed (power) (0-8);
to the left to decrease the suction speed (power) (8-0);
Suction Power Booster
The product is equipped with two additional suction speed
(power) levels (in addition to the level
- Tap and swipe with your fingers the Selection area (3) (in
addition to level
) and activate the Suction Power Booster
level 9 : remains active for 15 minutes
level 10 : remains active for 15 minutes
after that the power returns to level 8
Note: the active Suction Power Booster function is indicated
on the display (13) of the selected cooking zone with the
symbol "
".
Timer
Activation/Regulation of Timer function for the
extractor fan
• Select the extractor fan.
• Push
(8) to access the Timer function (at any
speed)
• Set the duration of the Timer:
press the selector
down time
push the selector
down time
display (15) will show the countdown,
)
, to increase the automatic shut-
, to decrease the automatic shut-
Note: the symbol "
extractor fan
When the timer has finished the count, it emits a beep (for 2
minutes; you can mute it by tapping
display (15) is flashing, showing the symbol " .
To switch-off the Timer:
• select the Selection zone (6)
• set the value of the timer to " " , via
Note: the function remains active if no other key is pressed
in the meantime.
Activation of filter saturation indicators
These indicators are normally deactivated
(for both the grease filter and the activated carbon filter)
To activate them, proceed as follows:
- switch on the extractor hob by means of
- with the suction motor and the cooking zones turned off,
push and hold down the Selection area (7):
the LED "
" (17) turns on at low brightness
the display (14) of the extractor fan shows the letter "G" – to
proceed with the activation of the grease filter saturation
indicator –
Note : push the Selection zone (7) again to display (14) the
letter "F" and proceed the odour carbon filter
Active
- push the Selection zone (6), the LED "
switches to high brigthness, then, after 10 seconds, it
turns off and indicates that the ACTIVATION was
completed.
Deactivation of filter saturation indicators
repeat the operation described above for activation;
- the LED "
after 10 seconds, it turns off to indicate that
DEACTIVATION was completed.
85
"(19) appears beside the display of the
;
" (17) switches to low brightness, then,
) , while the
".
" (17)