Bluetooth - Avinity ABT-632 Mode D'emploi

4.Getting Started
• The adapter is equipped with a recharge-
able battery. The battery must be fully
charged before using the device for the
first time.
• Begin charging by connecting the included
Micro-USB charging/connecting cable to
the adapter's Micro-USB connection (5)
and to a suitable USB charger. Please refer
to the operating instructions for the USB
charger used.
• The adapter's status LED (3) emits a con-
stant red light during charging.
• It can take up to 2 hours to fully charge the
battery.
• Charging begins and ends automatically.
5. Operation
5.1. Switching the adapter on/off
• Switching on:
With the device off, press and hold the
multifunction button (2) for 3 seconds. The
status LED (3) lights up in blue.
• Switching off:
With the device on, press and hold the
multifunction button (2) for 3 seconds. The
status LED (3) emits two red flashes before
the device turns off.
The first time the device is turned on, pairing
is automatically started – see 5.2 Blue-
tooth pairing in receiver (RX) mode.
®

5.2. Bluetooth

pairing in receiver (RX) mode
®
Note – Pairing
• Make sure that your Bluetooth®-ca-
pable terminal device is on and
Bluetooth® is activated.
• For more information, please refer
to the operating instructions of your
terminal device.
• Connect your terminal device to the adapt-
er using the included 3.5 mm jack cable
and the audio connection (AUX) (4).
• Select the adapter's RX mode by moving
the switch (1) to the right.
• The adapter and the terminal device should
be no further than 1 metre apart. The short-
er the distance, the better.
• With the adapter on, press the multifunc-
tion button (2) twice. After approximately
3 seconds, the status LED (3) will emit
flashes of alternating blue and red light to
indicate the device is in pairing mode.
• Open the Bluetooth
terminal device and wait until Avinity
BTT-632 appears in the list of Bluetooth
devices found.
• Select Avinity BTT-632 and wait until the
adapter is listed as connected in the Blue-
tooth settings on your terminal device.
®
settings on your
®
®