Hendi 239377 Mode D'emploi page 8

Error codes display
Error codes shown on the
display (5)
E01
E02
E03
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely
before cleaning and storage.
Cleaning
• Never immerse the appliance in water or other
liquids.
• Clean the cooled exterior surface with a slightly
damp cloth or sponge with some mild soap solu-
tion.
EN
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
Troubleshooting
If the appliance does not function properly, please
check the below table for the solution. If you are
still unable to solve the problem, please contact the
supplier/service provider.
Problems
The appliance does not switch ON.
Cooling fan is operating even after
the appliance is switched to OFF
mode.
8
Possible cause
The temperature of the appliance is too high
Cooling fan defective
The temperature of the cookware is too high.
Possibly, the cookware becomes empty and
appliance will shut down for protection.
The supply voltage is abnormal. (Supply volt-
age is too high or too low)
Possible cause
- Power plug is not connected properly
with the electrical outlet.
- Without switch ON the appliance by turn
ON the knob.
- This is normal. The cooling fan contin-
ues running for some time to cool down
all internal elements.
Possible solution
Unplug the appliance, remove the cook-
ware, wait until the appliance is com-
pletely cool down.
Check and clean the air inlet and outlet if
they are blocked. Contact the supplier if
fan is not work after clean.
Unplug the appliance, remove the cook-
ware, wait until the appliance is com-
pletely cool down.
Make sure that the appliance is connect-
ed to a suitable electrical power supply.
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
• Store the appliance in a cool, clean and dry place.
• Never put heavy objects on the heating surface
during storage as it may crack it.
• Error codes shown on the digital display (5). (See
--> Error codes display)
Possible solution
- Check the power plug to make sure
it is connected properly.
- Switch ON the appliance by turning
ON the knob.
- Wait until the cooling fan stops ro-
tating.