Toyotomi Zibro LC-300 Manuel D'utilisation page 11

i
cHilDPROOf lOcK / PaRental cOntROl
The childproof lock can be used to prevent children accidentally changing the
heater settings. When the heater is burning and the childproof lock is on, the
heater can only be switched off. Other functions are blocked then. If the heater has
already been switched off, the childproof lock also prevents accidental ignition
of the heater. Activate the childproof lock by pressing the appropriate key M and
holding it down for more than 3 seconds. The KEY-LOCK indicator
on the information display (Fig. I), indicating that the childproof lock has been
activated. Switch off the childproof lock by pressing the key M and holding it down
for more than 3 seconds once again.
J
tHe cORRect use Of 'save'
The 'SAVE' function allows you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature
exceeds the set temperature by 3°C. Subsequently, when the room temperature has
dropped again to the set temperature, the heater will automatically switch on again.
Activate the 'SAVE' setting by pressing the appropriate  key. The SAVE indicator
light will light up (Fig. J). Switch off the function by pressing the SAVE key once
again.
Without the 'SAVE' setting your heater will maintain the set temperature by
!
approximation as well, by adjusting its heating capacity. 'SAVE' is an economy
setting, which you can use when, for instance, you are not present in the room or
to keep it frost-free.
K
tHe 'fuel' inDicatOR
When the FUEL indicator appears, it means that there is only fuel left for 10
more minutes. The count-down of the remaining heating time can be seen in the
information display K (Fig. K).
You remove the fuel tank and refill it outside the living room (Section B).
In the display the number 10 will appear, you will hear an alarm signal every
two minutes, warning you to refill the removable tank. If you do not react, the
heater will extinguish by itself. The heater will also sound a warning signal,
when it switches off. The fuel indicator will blink, while four lines (--:--) are
blinking in the information display. You can stop this by pressing the
L once more.
Once the heater has used up all its fuel and extinguished, it will take some time,
after the refill, before the heater is completely ready for use again.
l
tHe 'vent' inDicatOR
When there is insufficient ventilation in the room, the heater shuts off
automatically. When this occurs, e -1 1 is displayed and the VENT indicator
blinking (fig. L). After improving the ventilation of the room (e.g. by opening a
door or window a little more), the heater can be ignited by pushing the
L again.
4
10
I: When the
appears, the childproof
will appear
lock has been activated.
J: When the SAVE light
lights up, the heater will
automatically switch on
or off in order to remain
within a specified tem-
perature range.
K: When the FUEL
indicator has appeard,
the information display
will show the number of
minutes of fuel left in
the tank.
button
is
L: A blinking VENT
indicator is a sign
button
that you need extra
ventilation.
Fuel filter
mark