Taking Photos - ION AIR PRO WiFi Guide De Démarrage Rapide

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
1. Whether the camera power is ON or OFF, simply slide the Recording Slide Switch
REC to start recording.
2. When your camera is OFF and the Recording Slide Switch
Power
button to turn the camera ON and it will start recording.
Move the Recording Slide Switch
and the LED indicator will illuminate GREEN to indicate the recording has stopped. The camera will then
enter Standby mode.
An additional option is to hold the Power
camera will vibrate two seconds and the Red LED light will turn off.
Notes
1. An additional 432x240 (w/ 1080p/720p) or 320x240 (w/ 960p) video file will be created simultaneously with
the recording of an HD/FHD video file. The smaller video file size allows for more efficient uploading of
content to social media sites and email.
2. Changing video resolution is disabled during video recording.
3. There will be around 1-2 seconds delay before the camera starts recording.
4. The various video resolution options for HD and FHD can be changed under the "Settings" selection in the
ion software.

2.6 Taking Photos

1. Turn on the camera by pressing the Power
2. After the camera power has been turned on, press the Power
and a flash of Green LED indicate the action was successful.
Notes
1. The Still Photo function is disabled during video recording.
2. Change photo resolutions and shot mode (Single Shot, Burst Mode and Time Lapse) through the "Settings"
section on the ion software.
2.7 CamLOCK Mount System
ion's versatile CamLOCK Mount System allows you to attach the AIR PRO camera to any type of helmet (bike,
motorcycle, ski, skydive etc.), pole, board (surf, skate, ski etc) and handlebar (bike and motorcycle).
Please refer to the specific mounting guides for instructions on how to install your mounts with your camera for
particular activities.
3. Using the WiFi PODZ
3.1 Install Your WiFi PODZ
1. Remove your PODZ and put your WiFi PODZ to the camera PODZ socket
2. Seal the camera by rotating the back cover and slide the latch until it is locked
3. Press and hold the Power
from REC to STOP to stop recording. The camera will vibrate
button to stop the recording and turn the camera off. The
button.
button to turn on your camera
is at REC location, press and hold the
button to take a photo. A short vibration
from STOP to
EN-4

Publicité

Table des Matières
loading

Table des Matières