Operating A Wireless Relay - JabloCom JabloPhone GDP-04i Guide Utilisateur

After pressing the panic button or activating the sensor, the emergency messages are sent first. Then
phone calls to the first phone number. When the call is connected, phone plays the voice message
twice and than connects audio to the hands free. When the call is finished, the phone calls to all other
numbers in the same way. The length of the call is limited to 5 minutes.
If you press a panic button during a ringing incoming call, the phone receives the call to the hands free mode.
Try the emergency function after completing settings.
Pressing the panic button during incoming call accepts the call on the handsfree. Phone can be ope-
rated by one wireless button both way (making calls, receiving calls).

Operating a wireless relay

A wireless relay can be operated via SMS sent to GDP-04i RF or from the phone's menu. All settings are done in the
m > s > w
enu ettings ireless relay
If you enter the m
thru all necessary settings.
To enroll GDP-04i RF into a new wireless relay (for example AC-88) switch the relay into the enrollment mode and
choose e
nroll new relay
For changing the output name go to the menu m
w > s
ireless relay ettings
Use m for switching between o
oDe
o /o mode, it reacts to the SMS message accordingly. If it is in the P
n FF
mode, it switches on only for 2 seconds.
For operating the outputs send an SMS to the GDP-04i RF phone number.
Syntax of the SMS is: <Action> <Output name> where:
<Action>
<Output name>
If you like to switch the output on for the limited time, send an SMS <a
Examples:
ON deviceX
OFF deviceY
ON deviceX 3:00:00
You can enroll GDP-04i RF into OASiS wireless relays AC-82, AC-83, AC-88 or UC-82.
If the command SMS beeps as a new on GDP-04i RF, the command wasn't recognized. Check
the message syntax in m
For more details about using the wireless devices please read the application note on www.jablocom.com.
GDP-04.i.ENG.MAN.User_Manual.15.B
menu.
> s > w
enu ettings
on the phone. The phone sends the enrollment signal immediately.
enu
. Use right arrow or green button to change it.
/o and P
. If the output is in the
n FF ulse
- is on for switching on the output, oFF for switching the output off.
This text cannot be changed and depends on the selected language.
- is Devicex or Devicey as a default. User can modify the output name.
Switches on permanently the output PgX of the wireless relay
Switches off permanently the output PgY of the wireless relay
Switches on for 3 hours the output PgX of the wireless relay
> s
enu ettings
menu for the first time, the phone guides you
ireless relay
> s >
ettings
ulse
> <o
ction
> w > h
ireless relay
- 15 -
> hh:mm:ss
utPut name
elP
EN