Troubleshooting - TAD -DA1000TX Mode D'emploi

TROUBLESHOOTING

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this
component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components
and electrical appliances being used. For information regarding computer settings, consult the TAD website (http://tad-labs.
com). If the trouble cannot be rectified even after exercising the checks listed below, ask your dealer.
Symptom
No sound is produced Input connector is not connected correctly.
even when input is
The mute mode has been set (the "0" indicator
correctly set.
is flashing).
Sound is too low.
Noise is audible even Noise is present in the power source itself.
when no input is
selected.
No sound is produced Digital connection is not correct.
for digital input.
On a CD player equipped with digital output
level adjustment, the output level is set too low.
The file format is not supported by the
computer's digital playback software.
No sound is produced ' The computer is set to a different input
for USB input.
' The computer's mute function is ON.
' Connections are wrong.
' The unit is not detected by the computer.
The file format, OS, or playback software is not
supported.
The USB input's Depending on the computer's setting, the
sampling rate is always sampling rate may remain the same even
the same. when playback files have different sampling
rates.
Computer sounds Depending on computer settings, the
(other than music computer's boot-up beeps or error sounds may
sounds) are audible be audible from the unit.
from the USB input.
When input is set to When not set to USB input, the computer
something other than doesn't recognize the unit.
USB, the unit can't
play music files on the
computer's playback
software.
The power turns off by If the ECO (power-saving) mode is turned ON,
itself. the unit will automatically enter standby mode
if no operation is performed on the unit for 30
minutes.
Possible cause
component.
Remedy
Check the connection.
Press the MUTE button on the main unit or
remote control to cancel the mute mode.
Adjust the volume.
Check your computer's power wiring; are too
many plugs connected to the same power outlet?
Check the digital connection.
Adjust the player's digital output level to an
appropriate level.
If the output device is set to a non-PCM audio
signal format (Dolby Digital, DTS, etc.), set it to
PCM.
Check the computer's sound settings.
' After the unit is connected to the computer,
if the unit's input is switched to USB, the
computer's sound setting may switch to
a different input component. In this case,
reselect TAD-USB1 ver2 or TAD-USB2 ver2 as
the input.
' Check the connections again.
Confirm that the OS, software, and file sampling
rate are supported (page 17).
Check the computer settings.
Check the computer settings.
Switch to USB input, and reset the computer's
sound setting to TAD-USB1 ver2 or TAD-USB2
ver2.
Set the ECO (power-saving) mode to OFF (page
18).
19