Connecting Up - TAD -DA1000TX Mode D'emploi

Convertisseur n/a
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22

Connecting up

CAUTION
' Do not turn on the power switch to the unit or the other components until all connections have been completed.
' When connecting components or changing connections, always set the power switch to OFF and disconnect the power
cord from its AC outlet. When making connections, connect the power cord last.
1.
Connect other components.
2.
Connect the supplied power cord to the unit's AC IN connector.
3.
Connect the power cord to a standard electrical outlet.
When connecting a device equipped with the
pre-amplification feature
1. Turn on power to both the unit
and computer.
2. Switch the unit's input to U1.
3. Using a USB cable, connect
the computer and unit; when
this is done the proper driver
will be automatically installed
(page 17).
BALANCED
output connector
(XLR-3-31 equivalent)
1
3
1: Ground
2: Hot
3: Cold
Pre-Amplifier with balanced input connectors
Note
About the balance/unbalance line output level
' The initial value for the line output is set at 30. For details, refer to To fix the line output levels at their maximum on page 16.
14
Computer with USB port
R
L
R
L
BALANCED
UNBALANCED
2
Component with digital output connector
USB
XLR
COAXIAL
OPT
12 V
XLR
COAXIAL
D1
D2
D3
D4
TRIGGER
OUT
DIGITAL INPUT
R
L
Pre-Amplifier with unbalanced input connectors
In case of a power amplifier with a 12 V
trigger input terminal.
Commercially available 3.5Φ monaural
pin cable (without resistance)
Power cord
(supplied)
AC IN
Component with digital
input connector
To AC
Power outlet

Publicité

Table des Matières
loading

Table des Matières