Troubleshooting - AEG FAVORIT 50KVI1P Notice D'utilisation

32 www.aeg.com
To prevent this, we recommend to run
long duration programmes at least 2
times per month.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with
water.
Problem
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
The appliance does not drain
the water.
The anti-flood device is on.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes,
contact the Service.
•
- The appliance does not drain
the water.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse
in the fuse box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or
wait for the end of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is
not clogged.
Make sure that the inlet hose has no kinks or
bends.
Make sure that the sink spigot is not clog-
ged.
Make sure that the drain hose has no kinks
or bends.
Close the water tap and contact the Service.
10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is
too much. Adjust the rinse aid selector
to a lower position.