Erreka VIVO-D102 Manuel De L'installateur page 44

INSTALLATION
Connection of safety transmitter-receiver photocells in closing (SG.C)
FT06
Safety contact connection in opening (SG.A) for pedestrian door
A
B
44
Installation Manual
COM
SG.C
– FT (test)
+ FT (test)
P155I
P155P

We recommend installing
photocells.
1 Complete the connections as shown in the figure.

If neither photocells nor a mechanical strip are used,
place an electrical bridge between cable connectors
3 and 4 of the control board (COM - SG.C).
2 Duly programme the operator:

Closing photocells with pre-testing: C511

Closing photocells without pre-testing: C510

Without closing photocells: C500

For further details on programming, see "Starting
up and programming" on page 46.

If there is a pedestrian door (B) in the main
door (A), make sure the main door does not
open when the pedestrian door is open by
installing an NC contact (normally closed).
1 Install the NC contact in the door so the contact
remains closed when the pedestrian door (B) is
closed, and opens when the pedestrian door (B)
opens.
2 Complete the connections as shown in the figure
(cable connectors 3 and 5).
3 Programme the operator:

Contact installed: C410.

Programme C400 if the contact is not installed
because there is no pedestrian door in the main
door.

For further details on programming, see "Starting
up and programming" on page 46.
closing safety