Installation - Electrolux EHM6532IWP Notice D'utilisation

14 www.electrolux.com
comes on
and number comes
on.
comes on
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit letter
code for the glass ceramic (it is in the cor-
ner of the glass surface) and an error
message that comes on.

8. INSTALLATION

WARNING!
Refer to the Safety chapters.
Problem Possible cause
No cookware is on the
cooking zone.
Incorrect cookware.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
There is an error in the
appliance.
There is an error in the
appliance because a
cookware boils dry. The
overheating protection for
the cooking zones and
the Automatic Switch Off
operate.
Make sure, you operated the appliance
correctly. If not the servicing by a custom-
er service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the cus-
tomer service and conditions of guarantee
are in the guarantee booklet.
Remedy
Put cookware on the
cooking zone.
Use the correct cook-
ware.
Move cookware to a
smaller cooking zone.
Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If comes on again,
speak to the service cen-
tre.
Deactivate the appliance.
Remove the hot cook-
ware. After approximately
30 seconds, activate the
cooking zone again. If the
cookware was the prob-
lem, the error message
goes out of the display,
but the residual heat indi-
cator can stay. Let the
cookware become suffi-
ciently cool and refer to
"Cookware for the induc-
tion cooking zone" to see
if your cookware is com-
patible with the appli-
ance.
Before the installation