Asist AE2C07DN Mode D'emploi page 49

noise, dust and vibrations!!! KEEP
THESE SAFETY INSTRUCTIONS FOR
FUTURE REFERENCE!!!
DESCRIPTION (A)
This cordless precision drill/sander is intended for
drilling, milling, engraving, polishing, cleaning,
grinding, cutting of materials such as wood, metal,
plastics, ceramics and stone in dry rooms using
the corresponding attachments (as supplied). Any
other usage of or modifi cation to the appliance is
deemed to be improper and carries a signifi cant
risk of accidents. The manufacturer accepts no
responsibility for damage(s) attributable to misuse.
This appliance is not intended for commercial use.
1. Lock nut
2. LED work light
3. Front handle
4. Spindle lock
5. On / Off button
6. Vents
7. Rear handle
8. Charging ports
9. Battery level indicator
10. Speed switch
11. Speed and charge indicators
12. Keys
13. Charger
14. Charging port
15. Accessory holder
16. Charging station
17. Charging socket
PICTOGRAMS
Pictograms stated on the product packaging:
a) Power supply values
b) Power
c) Idle speed
d) Clamp bushing
USE AND OPERATION
The ASIST power tool is designed for domestic or hob-
by use only.
The manufacturer and the importer do not recommend
to use this equipment under extreme conditions and at
high loads. Any other additional requirements must be
agreed upon by the manufacturer and the buyer.
Charging the battery
1. Connect the charging cable connector with the
charging socket of the device.
2. Plug the charger into an electrical outlet.
3. After the charging process, disconnect the charger
from the mains supply.
Checking the battery charge level
If the appliance is switched on, the status/remaining
charge will be shown on the battery LED as
follows:
GREEN = maximum charge
ORANGE = medium charge
RED = low charge – charge the battery
Changing/inserting the tool/collet chuck
♦ Press the spindle lock and hold it down.
♦ Turn the tensioning nut until the lock clicks into place.
♦ Undo the tensioning nut from the thread
using the combination spanner .
♦ Remove any tool which is inserted.
♦ First push the intended tool through the tensioning
nut before inserting it into the appropriate collet chuck
for the tool shaft.
♦ Press the spindle lock and hold it down.
♦ Push the collet chuck into the thread insert and
screw the tensioning nut
Switching ON and OFF
1. Press the on/off switch to start the device.
49