Programming Additional Transmitters; Installing The Wall Bracket - Becker Centronic SunWindControl SWC241-II Notice De Montage Et D'utilisation

2) Programming additional transmitters

1. Press the programming button of the master transmitter until the re-
ceiver confirms.
2. Then press the programming button of the new transmitter until the re-
ceiver confirms.
3. Now press the programming button of the new transmitter again.
4. The receiver confirms successful programming.
The maximum transmitter range on and in the building is up to 25 m, and up to
350 m in the open.

Installing the wall bracket

Wall bracket
Wall bracket
mounting
plate
Unlocking mechanism
• Before installation in the desired
installation position, check that
the transmitter and receiver are
functioning properly.
•
Fix the bracket to the wall with the
two screws enclosed.
19 - en