G Operating instruction
Thank you for choosing a Thomson product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference. If
you sell the device, please pass these operating
instructions on to the new owner.
1. Explanation of the Notes
Note
This symbol is used to indicate additional
information or important notes.
2. Package Contents
• M135/M135D microphone
• Permanently attached 3 m microphone cable,
3.5 mm mono jack
• 3.5 – 6.3 mm mono jack adapter
• This operating instruction
3. Safety Notes
• The product is intended for private, non-
commercial use only.
• Protect the product from dirt, moisture and
overheating and use it in dry rooms only.
• As with all electrical devices, this device should be
kept out of the reach of children.
• Do not drop the product and do not expose it to
any major shocks.
• Do not open the device or continue to operate it if
it becomes damaged.
• Do not modify the device in any way. Doing so
voids the warranty.
4. Startup and Operation
• Ensure that the microphone is switched off (Pic. 1).
• Connect the 3.5 mm mono jack plug with your
terminal device's microphone input (Pic. 2a). If
your terminal device has a 6.3 mm jack input for
microphones, use the included 6.3 mm mono jack
adapter (Pic. 2b).
• Switch on the microphone (Pic. 3).
2
Note - A Few Tips
• Always position your microphone so that it is as
close to and as directly connected to the audio
source as possible.
• Hold your microphone as still as possible to
prevent interference and wind noise.
• Check the functionality and the transmitted
volume (sound check) before using the
microphone.
• In case of feedback (loud screeching)
immediately switch off the microphone using
the integrated on/off switch. Then eliminate
the cause of the feedback, e.g. by reducing the
volume of the speakers or the input sensitivity
(gain or pad, where applicable) of your
microphone input, and/or moving somewhat
behind your speaker(s) before switching the
microphone back on.
5. Care and Maintenance
• Only clean this product with a slightly damp,
lint-free cloth and do not use aggressive cleaning
agents.
6. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
7. Service and Support
Please contact Hama Product Consulting if you have
any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com