Parkside PKSA 20-Li A1 Traduction Des Instructions D'origine page 10

Noise emission value:
Noise measurement value determined in accordance
with EN 60745-2-13. The A-rated noise level of
the power tool is typically:
Sound pressure level: L
Uncertainty K:
Sound power level:
Uncertainty K:
Guaranteed sound
power level:
Wear ear muffs!
Total vibration value:
Total vibration values (vector total of three directions)
determined in accordance with EN 60745-2-13:
Vibration at the handle:
a = 7.3 m/s 2 , K = 1.5 m/s
h
WARNING!
► The vibration level varies depending on the
use of the power tool and may be higher
than the value specified in these instructions
in some cases. Regular use of the power tool
in this way may cause the user to underesti-
mate the vibration. Try to keep the vibration
loads as low as possible. Measures to reduce
the vibration load are, e.g. wearing gloves
and limiting the working time. Wherein all
states of operation must be included (e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
│ GB │ IE │ NI
■ 4
= 86.3 dB (A)
pA
(at operator position)
K = 3 dB
pA
L = 94.7 dB (A)
WA
K = 2.6 dB
WA
L = 97 dB (A)
WA
(according to 2000/14/EC
amended by 2005/88/EC)
2
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance
with the standardised measuring procedure
specified in EN 60745 and can be used to
make equipment comparisons. The specified
vibration emission value can also be used to
make an initial exposure estimate.
WARNING!
► You can reduce the vibration risk, for example,
the risk of Raynaud's phenomenon (circulatory
problems), by taking regular breaks during
which you rub your hands together.
The following symbols are used in these
operating instructions/on the tool:
Read these operating instructions
thoroughly before using the tool for
the first time, and retain them for
future reference.
Warning! Read the operating
instructions before use!
WARNING! Special safety precau-
tions are required when working
with the chainsaw.
Read and observe all warnings!
Wear snugly fitting protective
clothing with a cut-resistant lining.
Wear a hard hat!
Wear safety goggles!
Wear ear muffs!
Wear protective gloves!
Wear non-slip safety shoes!
PKSA 20-Li A1