Option Menu List - Yamaha CRX-N560 Mode D'emploi

Option settings

Option menu list

Menu Sub menu Default
1
Preset Delete* ( P.24, 27) Deletes preset stations.
Scans all receivable frequencies and registers them in
1, 2
Initial Scan* * ( P.23)
the unit.
1, 2
DAB Tune Aid* * ( P.25) Shows the level of received DAB signal.
EQ Low 0 Adjusts low frequency.
Equalizer
EQ Mid 0 Adjusts middle frequency.
( P.22)
EQ High 0 Adjusts high frequency.
Adjusts the volume balance of the left and right
Balance ( P.22) CENTER
speakers.
OFF
Music Enhancer ( P.22) Enables/disables Music Enhancer.
Timer Setting ( P.32) Sets the wake-up timer.
Network
Shows connection status of the unit and network.
Status
MAC Address Shows MAC address.
Network
Info
System ID Shows the system ID.
Network Shows the name of the unit that appears on the
Name network.
36
En
Function
Network
Config
System
Config
Advanced
Setup
(
*1 Only when the radio is played back
*2 CRX-N560D only
Menu Sub menu Default
DHCP Enabled YES Enables/disables DHCP.
IP Address 0.0.0.0 Confirms and sets the IP address.
Subnet Mask 0.0.0.0 Confirms and sets the subnet mask.
Def. Gateway 0.0.0.0 Confirms and sets the default gateway.
DNS Server(P) 0.0.0.0 Confirms and sets the primary DNS server.
DNS Server(S) 0.0.0.0 Confirms and sets the secondary DNS server.
Clock Setting Sets clock of this unit (
Power Saving Eco Sets the eco standby (
Auto Power
Timer 8H Sets the unit into standby mode automatically (
Off
Selects whether or not to supply power to a Yamaha
Use Accessory NO
accessory connected through the DC OUT jack.
Firm Version
Shows the firmware version of the unit.
Firm Update Network Updates the firmware of the unit (
Specifies the MAC address (up to 5) and restricts access
MAC to this unit of network components.
OFF
Add.Filter (Operation with AirPlay is not affected even if [MAC
Add.Filter] is set to [ON].)
P.35)
Factory Reset Resets the unit's settings to factory default.
Function
P.31).
P.12).
P.12).
P.34).