BERTO'S MACROS 700 Mode D'emploi page 115

Switching the FE1, FE2 and TE electric oven on and off.
Turn on the switch upstream of the appliance.
For turning on the appliance, rotate the knob (A) to the set
temperature; the pilot light (B) switches on to indicate the
oven is operating; the pilot light (C) switches on to indicate
that the heating elements is ON.
The light (C) switches off when the set temperature is
reached; the heating element is off and the fan continues
working.
When the temperature goes below the set value, the light
(C) switches on and the heating element is on again.
To switch off the oven, rotate both knobs to the "O"
position. The first position of the knob activates the fan
(only the green light (B) is on); this is used for cooling or
defrosting operations.
WARNING!
Never use the oven without the bottom of the chamber.
Pay attention to hot steam coming out from the oven
when the oven door is open.
MAINTENANCE
CARE OF THE APPLIANCE
ATTENTION!
- Before cleaning, switch off the unit and let it cool down.
- In the event of electrically supplied units, use the
isolator switch to disconnect the mains.
Carefully, clean the appliance daily to guarantee its proper
operation and long life.
Steel surfaces must be cleaned with a dish washer
detergent diluted in very hot water and a soft cloth;
for the toughest dirt, use ethylic alcohol, acetone or
another non-halogenated solvent; do not use abrasive
powder detergents or corrosive substances such as
hydrochloric acid, muriatic or sulphuric acid.
The use of acids can affect the unit's operation and
safety.
Do not use brushes, steel cottons or abrasive disks made
with other metals or alloys that might cause rust stains due
to contamination. For the same reason, avoid contact with
iron objects.
Do not use steel cottons or stainless steel brushes because
thile they will not contaminate surfaces, they can cause
damaging scratches. If dirt is tough, do not use sandpaper
or rough paper, but use synthetic sponges (for example
Scotchbrite sponges). Do not use substances for cleaning
silver and be careful with hydrochloric or sulphuric vapors
coming from washing products, for example.
Don't clean the unit with direct water jets or steam
cleaners.
After cleaning, rinse it properly with clean water and
carefully dry it with a cloth.
REPLACEMENT OF THE COMPONENTS
(SPARE PARTS)
Use only original spare parts supplied by the
manufacturer.
All maintenance must be carried out by qualified
personnel. The appliance should be serviced at least
once a year, which is why we recommend signing
our maintenance agreement. Replacing the heating
elements of electric ovens
Disconnect the switch upstream of the appliance so that
the unit will be disconnected from the mains. In the FE
oven, the lower heating elements are positioned under the
bottom and the upper heating elements are positioned on
the upper side of the cooking chamber. In the FE1, FE2,
TE oven, the heating element is positioned behind the
conveyor on the rear of the cooking chamber. To remove
the heating elements, loosen the screws fixing them;
pay attention to the connection leads. Use a screwdriver
to disconnect the connection leads and mount a new
heating element following the sequence in reverse.
LONG PERIODS OF APPLIANCE INACTIVITY
If the appliance is not used for long periods of time, please
observe the following:
1) Switch of the disconnecting switch to disconnect unit
from the mains
2) Clean the equipment and the surrounding areas
properly
3) Pour a small quantity of cooking oil on the stainless
steel surfaces
4) Carry out all maintenance operations
5) Cover the appliance with a suitable material and leave
a few openings to allow air to circulate.
WHAT TO DO IN THE EVENT OF A FAILURE
In the event of a failure, immediately disconnect the unit
from the mains and call for the Technical Assistance.
| 115
EN