Troubleshooting; Resolving Problems - Ardo CDR07SU Mode D'emploi

16
17
All electric appliances may break-down at some time.
Remember to call a qualifi ed technician in these cases. However, many problems can be resolved without
the need for external intervention.
Important: If a fault occurs, disconnect the appliance from the mains supply immediately.
Before calling the customer service centre, check the points listed below.
If the drier doesn't start
• Check that:
1) The appliance is plugged into the mains
supply.
2) The mains socket is working correctly:
2a) The fuse has not blown. (Check by
plugging in another appliance such as a table
lamp and see if that works)
2b) All the instructions in the manual have been
followed.
If, after all these checks have been carried out, the appliance still does not work, inform the
nearest customer service centre. When contacting the service centre, inform them of the
appliance model, serial number and type of fault. This information will help the service centre
operator in procuring the necessary spare parts, thus guaranteeing a speedy and effi cient
repair.
SM2164
MAINTENANCE
CLEANING AND MAINTENANCE
Rotate the 3 levers to the vertical position and remove the condenser (fi g. 16).
18

TROUBLESHOOTING

RESOLVING PROBLEMS

Wash the front, back and sides of the condenser,
aiming the jet of water as shown (fi g.17/18).
To dry the condenser thoroughly, place it on its
side on a towel.
When the condenser is dry, replace it following
the same procedure in reverse order.
If the drier doesn't start
• Check that:
1) The door is closed properly
2) The start button has been pressed.
The washing does not dry
• Check that:
1) The air exhaust aperture is not blocked.
2) The fi lter is not blocked. (Remember that
when the door is opened, the internal
parts of the drier and the washing may
be very hot).
21
GB