Teka HL-820 Guide Rapide D'utilisation page 16

3. Next, touch the + or – symbols to pro-
gramme the cooking time.
4. After a short time, the oven will beep and
you will see on the display how the pro-
grammed time will start to count down, while
the cooking is underway. The AUTO symbol
will remain lit up.
5. After this, an alarm will sound and the oven
will turn off.
6. 0:00 and AUTO will flash on the display.
7. Touch the symbol + or – to turn off the
AUTO reading.
8. Finally, set the controls to position
off the oven.
NB
If you do not set the controls in position
a short space of time the oven will continue to
cook manually.
With this function, any grease or dirt that is
stuck to the walls of the oven can easily be
removed through the combined action of
Teka Hydroclean
steam and the excellent properties of the new
®
enamel.
How to use the oven cleaning cycle
Always use the cleaning programme with a
cold oven.
CAUTION
Do not pour water inside the oven when hot
because it may damage the enamel inside.
16
to turn
, after
Teka Hydroclean
At any time, you can turn off the oven turning
the controls to position
You can modify the programmed duration of
cooking first by pressing + and then the sym-
bols + or –.
Child Safety Function
To activate the function, press the + and – sen-
sors at the same time for several seconds. You
will hear a beep and see the word SAFE on the
display.
If this function is activated while you are cook-
ing, it will only lock the electronic timer settings.
If a timer sensor is touched while the child safe-
ty function is on, the word SAFE will appear on
the display.
To disable the function, press the + and – sen-
sors at the same time for several seconds until
you hear a beep.
®
Cleaning function
1. First remove the trays and all accessories
from the oven interior, including the tray
supports and telescopic guide rails.
Caution
time using the Teka Hydroclean
Do not clean the oven and tray at the same
you will not obtain good results.
.
®
function as