DeWalt DCW600 Guide D'utilisation page 13

Fig. H
36
37
35
38
36
37
Attaching a Dust Extraction System to the
Fixed Base (Fig. I)
(Included with some models)
To connect the router to a dust extraction system for dust
collection, follow these steps:
1. Remove the motor unit from the base. Refer to
Removing the Motor from the Fixed Base.
2. Attach dust extraction system attachment accessory
to the base as shown. Tighten thumb screws
securely by hand.
3. Attach hose adapter to dust extraction system
attachment accessory.
4. When using dust extraction system attachment, be
aware of the placement of the dust extraction system.
Be sure that the dust extraction system is stable and that
its hose will not interfere with the work.
Fig. I
28
Attaching a Dust Extraction System to the
Plunge Base (Fig. J)
(Included with some models)
1. Remove the motor unit from the base. Refer to
Removing the Motor from the Plunge Base.
2. Slide tab 30 (inset) on dust extraction system
attachment 34 into slot in plunge base and snap
tab 31 (inset) into hole in plunge base.
3. Secure to base with supplied plastic washer
36
thumb screw
by hand.
4. Attach hose adapter to dust extraction
37
system attachment.
When using dust extraction system attachment, be aware
of the placement of the dust extraction system. Be sure
the dust extraction system is stable and its hose will not
interfere with the work.
Fig. J
33
32
Set-Up: Fixed Base (Fig. A, K, L)
Inserting the Motor into the Fixed Base
28
1. Open the locking lever
29
2. If the depth adjustment ring
thread the depth adjustment ring onto the motor until
the ring is about halfway between the top and bottom
of the motor as shown. Insert the motor into the base
by aligning the groove on the motor
pins
depth adjustment ring snaps into place.
nOTE: Guide pin grooves
of the motor so it can be positioned in two orientations.
3. Adjust the depth of cut by turning the depth
adjustment ring. Refer to Adjusting the Depth of Cut.
4. Close the locking lever
is achieved.
29
33 . Tighten thumb screw securely
30
12 on the base.
5 is not on the motor
17 on the base. Slide the motor down until the
9 are located on either side
12 when the desired depth
Fig. K
21
12
English
32 and
34
31
6 ,
6 with the guide
21
11