DeWalt D28700 Guide D'utilisation page 14

Troubleshooting Guide...
TROUBLE! DOES NOT MAKE ACCURATE CUTS
WHAT'S WRONG?
1. Fence not adjusted correctly.
2. Wheel is not square to fence.
3. Excessive force used to make cut.
4. Work piece moving.
TROUBLE! CANNOT MOVE ARM
WHAT'S WRONG?
1. Lock down pin is engaged.
TROUBLE! MATERIAL MOVES DURING CUT
WHAT'S WRONG?
1. Fence slipping or workpiece incorrectly placed or clamped.
2. Vise too loose
3. Excessive cutting force.
WHAT TO DO...
1. Check and adjust. See Fence Operation on page 6.
2. Check and adjust.
3. Reduce cutting force, let the wheel do the work.
4. Clamp workpiece securely. See Material Clamping and
Supporting page 5. Make sure material is laying flat against
the base.
WHAT TO DO...
1. Push down slightly on the arm, pull down lock down pin
and raise arm.
WHAT TO DO...
1. See Material Clamping and Supporting page 5.
2. Tighten vise clamping.
3. Reduce cutting force.
12