Table des Matières
Publicité
12
Off
14
15
17
Fitting the Brush / Pad.
Push in the deck locking pin
(Fig.10) and rotate the
brush deck into the
operating position (Fig.11).
Turn on the clean water tap
On
(Fig.12).
To start: hold either trigger and
press the yellow On / Off Switch
once to start the machine. (Fig.13).
Brush, vacuum and water settings
can be controlled from the control
panel (See Page 34).
Hold down either trigger to make the machine move.
For a speed boost when moving the machine press the grey fast moving
lever down (Fig.14).
Direction is controlled using the
direction switch fitted to the left
side of the handle (Fig.15).
The speed is controlled by the
speed control knob fitted to the
right hand side of the handle
(Fig.16).
Located on the left side of the machine is the Free Wheel lever.
To disengage the brake / drive mechanism, pull the lever out and move it to
the lower hole position (Fig.17).
This allows the machine to be moved in free wheel mode, for more
information (see page 36).
Note:
When the machine is in free wheel mode the brake has been disengaged,
avoid slopes.
Fill the clean-water to a Max of 40 litres (see page 28)
For operation and cleaning controls (see page 34)
22
11
10
13
16
Publicité
Table des Matières
