Dishwasher Control Section - KENMORE ELITE ULTRACLEAN 665.1479 Série Guide D'utilisation Et D'entretien

Masquer les pouces

Table des Matières

Les langues disponibles

Options

High Temp Wash

Raises main wash temperature to improve

cleaning for loads containing tough, baked

on food.

Sani Rinse

Sanitizes dishes and glassware in accordance

with NSF International NSF/ANSI Standard

184 for Residential Dishwashers. Certified

residential dishwashers are not intended for

licensed food establishments. Only sanitizing

cycles have been designed to meet the

requirements of the NSF/ANSI 184

performance standard for soil removal and

for sanitization efficacy. There is no intention,

either directly or indirectly, that all cycles on

a NSF/ANSI 184 certified dishwasher meet

the NSF/ANSI 184 performance standard for

soil removal and for sanitization efficacy.

The Sani Rinse indicator indicates at the end

of the cycle whether the Sani Rinse option

was successfully completed. If the indicator

does not activate, it is probably due to the

cycle being interrupted.

Smart Dry

Turns the heat element on at the end of the

wash cycle. Use rinse aid with or without the

Smart Dry option for best drying results.

Plastic items are less likely to deform when

loaded in the top dish rack.

Top Rack Only

For added convenience, use for washing a

small load of dishes in the top rack to help

keep the kitchen continuously clean.

Bottom Rack Only

For added convenience, use for washing a

small load of dishes in the bottom rack to

help keep the kitchen continuously clean.

**The maximum additional water used for any combination of options is 7.1 gal. (27.0 L).

Delay Hours

Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak

hours when possible.

To delay the start:

1. Select a wash cycle and options.

2. Press DELAY HOURS to choose the number of hours to be delayed.

3. Press START/RESUME.

NOTE: Anytime the door is opened for more than 5 seconds (such as, to add a dish), the Start/Resume button must be pressed

again to resume the delay countdown.

Can be selected

with

H E

SmartWash

Raises the main wash

Pots & Pans

temperature from 120°F

Normal Wash

(49°C) to 140°F (60°C).

H E

SmartWash

Increases the main wash

Pots & Pans

temperature from 120°F

Normal Wash

(49°C) to 140°F (60°C) and

Top Rack Only

the final rinse from 140°F

Bottom Rack Only

(60°C) to 155°F (68°C).

Available with any

Turns the heat element on at

cycle except Quick

the end of the wash cycle.

Rinse

Slightly faster wash for

Available with any

smaller loads

cycle

Cannot be used with

TurboZone

option

Available with any

cycle

Slightly faster wash for

smaller loads

Cannot be used with

TurboZone

option