Rinse Aid - KENMORE ELITE ULTRACLEAN 665.1479 Série Guide D'utilisation Et D'entretien

Rinse Aid

IMPORTANT: Your dishwasher is designed to use rinse aid. The
use of rinse aids greatly improves drying by allowing water to
drain from the dishes after the final rinse. They also keep water
from forming droplets that can dry as spots or streaks.
Filling the dispenser
The dispenser holds 5 oz. (150 mL) of rinse aid. Under most
conditions this will last 1 to 3 months.
1. To add rinse aid, open the rinse dispenser lid by gently
pushing in the center of the lid with your thumb and pulling
up on the edge.
2. Pour rinse aid into the opening until the dispenser is full. Do
not overfill.
3. Clean up any spilled rinse aid. Spilled rinse aid can create
excessive suds.
4. Then, close the dispenser by pushing down gently on the lid.
NOTE: Indicator reads correct fill level when door is completely
opened.
Full
Add
Rinse Aid Setting
Your rinse aid dispenser is adjustable. For most water conditions,
the factory setting will give good results. If you have hard water
and notice calcium buildup on your dishware, you may want to try
a higher setting. If you notice foam in your dishwasher, use a lower
setting.
To adjust the setting
Turn the arrow adjuster to a higher setting to increase the
amount of rinse aid.
11