Maytag W10680141C Guide D'utilisation page 6

6 OPTIONS
Use to select available options for your dryer. Not all cycles
and options are available on all models.
Energy Saver
Activate the ENERGY SAVER setting to increase your
energy savings. This setting uses a lower heat level and
extends cycle time. Turn on for optimal energy savings.
Turn off for optimal cycle times. ENERGY SAVER will
default on for Normal.
NOTE: Energy savings is not available on all cycles and
may vary across loads and cycles.
Static Reduce (on some models)
Touch to add the Static Reduce option to selected Sensor
cycles (see "Cycle Guide"). The dryer will automatically
tumble, pause, and introduce a small amount of moisture
into the load to help reduce static. This option adds
approximately 8 minutes to the total cycle time.
Damp Dry Signal
Touch to select the Damp Dry Signal to Low, High, or
Off. When selected, a series of beeps will sound when
the load is damp, but not completely dry. This will allow
you to take clothes out of the load that do not need to dry
completely. This option is not available on Sanitize, Steam
Refresh, and the Timed Dry cycles.
Audio Level
Touch AUDIO LEVEL to change end beep and button
sounds simultaneously to Low, High, or Off.
6
CYCLE STATUS LIGHTS
7
The indicator bar on the right side of the control will let you
know what stage of the drying cycle is in process. For more
information on each stage, see "Cycle Status Indicators. "
Sensing
The Sensing indicator will light during Sensor Cycles
to indicate that the moisture sensor on the dryer is
operating. This indicator will not light during Timed
Cycles or options such as Wrinkle Prevent.
Check Vent
The Check Vent indicator will light if there is a blocked
vent or low airflow.
Good Airflow
This indicator will light if there is no major vent
blockage.
Steam
This indicator will light when a steam function is
active.
NOTE: Steam is not available on all models or
on all cycles.
Done
This will indicate that the selected cycle has ended
and the load may be removed from the dryer. If
Wrinkle Prevent has been selected, the dryer may
continue to tumble the load, even if the Done
indicator is lit.
Check Lint Screen
The Check Lint Screen indicator light will flash as a
reminder to clean the lint screen. It will flash until the
door is opened or a cycle is started. It will turn off
when the dryer is turned off.