Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Installation - Ducting version
•
Cut a hole in the bottom of the cabinet in order to settle
the hood.
IMPORTANT- Cabinet must be capable of supporting
100 lbs.
•
Adjust the position of the clasping side spring by means
of the proper screw, according to the thickness of the
panel to which it is going to be anchored.
•
Insert the hood in the cabinet and lock it by means of the
side spring.
WARNING: 2 people are required to lift and position the
hood onto the mounting screws.
•
Use the holes in the casing of the hood to attach it using
8 mounting screws.
Connecting the ductwork
•
Install ductwork, making connections in the direction of
airflow as illustrated.
•
Push duct over the exhaust outlet.
•
Wrap all duct joints and the flange connections with duct
tape for an airtight seal.
•
Make the same connection in the wall or ceiling vent
exit.
Electrical connection
WARNING
Electrical Shock Hazard
Warning: Turn off power circuit at the service panel
before wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE
MUST BE CONNECTED TO THE GROUNDING WIRE
IN YOUR HOME ELECTRICAL SYSTEM, AND IT
MUST UNDER NO CIRCUMSTANCES BE CUT OR
REMOVED.
Failure to do so can result in death or electrical
shock.
Remove the knockout and the Junction box cover and
install the conduit connector (cULus listed) in junction
box.
8
Publicité
Table des Matières
