Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(3) Remove the end of the pig-tail on the carbon
brush from the terminal section of brush holder
and then remove the carbon brush from the
brush holder.
<Assembly>
(1) Insert the end of the pig-tail of the carbon brush
in the terminal section of brush holder.
(2) Insert the carbon brush in the brush holder.
(3) Use the auxiliary hexagonal wrench or small
screwdriver to return the edge of the spring to
the head of the carbon brush.
NOTE:
Make sure the end of the spring is not holding the
pig-tail.
(4) Mount the tail cover and tighten the D4 tapping
screw.
Brush
Carbon
Spring
Holder
Brush
WARNING: ALWAYS use Only authorized HITACHI replacement parts and accessories. NEVER use
replacement parts or accessories which are not intended for use with this tool. Contact HITACHI
if you are not sure whether it is safe to use a particular replacement part or accessory with
your tool.
The use of any other attachment or accessory can be dangerous and could cause injury or
mechanical damage.
NOTE: Accessories are subject to change without any obligation on the part of the HITACHI.
STANDARD ACCESSORIES
(1) Wrench (43/64''(17 mm)) (Code No. 936638) ..... 1
(2) Wrench (15/32''(12 mm)) (Code No. 936553) ..... 1
(3) Side Handle (Code No. 329758) .......................... 1
Fig. 8
ACCESSORIES
5. Service and repairs
All quality power tools will eventually require
servicing or replacement of parts because of wear
from normal use. To assure that only authorized
replacement parts will be used, all service and
repairs must be performed by a HITACHI
AUTHORIZED SERVICE CENTER, ONLY.
6. Service parts list
CAUTION
Repair, modification and inspection of Hitachi
Power Tools must be carried out by a Hitachi
Authorized Service Center.
This Parts List will be helpful if presented with the
tool to the Hitachi Authorized Service Center when
requesting repair or other maintenance. In the
operation and maintenance of power tools, the
safety regulations and standards prescribed in
each country must be observed.
MODIFICATIONS:
Hitachi Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without
prior notice.
OPTIONAL ACCESSORIES
Collet chuck (for 1/8''(3.175 mm) shaft)
Dimensions and handling methods other than the
shaft hole are the same as those for the 1/4''(6 mm)
collet chuck.
Case
NOTE:
Specifications are subject to change without any
obligation on the part of the HITACHI.
English
......... sold separately
13
Publicité
Table des Matières
