Hornbach 10252573 Manuel D'installation Et D'utilisation page 46

III.2. Installation of the covers
If the new pitch angle set is greater than 15 degrees, it is necessary to remove wall teeth from the
cassette support to adapt it to the new configuration.
Use pliers to remove one tooth at a time, from the cassette support. The total number of teeth to be
removed is explained in the table below.
Pitch angle
[deg]
[5..20]
[21..40]
[41..50]
[51..60]
III.3. Manually opening the awning
Install the hand crank in the eyelet
allocated for, on the right side of the
awning.
Please keep the hand crank vertical
while operation to protect the eyelet
from damage.
The rotation of the hand crank in the
two directions allows the opening or the
closing of the awning.
Note: that the use of the hand crank is
intended for emergencies (e.g. blackout,
breakdown of the product, ...)
46 | ENGLISH
Number of wall teeth to
be removed
0
1
2
3
Wall teeth