Dispensing Module - Miele professional PG 8055 Mode D'emploi

en - Operation
If liquid cleaning agent dispensing is not

being used, add powder cleaning agent
directly onto the inside of the door.
To avoid corrosion or discolouration, start
the wash programme immediately after
dispensing cleaning agent directly onto
the inside of the door.

Dispensing module

In addition to the internal dispensing sys-
tems, up to two additional external dispens-
ing systems (modules) DOS can be connec-
ted for dispensing liquid process chemicals.
Refilling or changing containers
The dispensing module is equipped with a
level monitoring indicator which shows a
message in the display when the level drops
below the minimum.
DOS
Refill
As soon as the message appears in the

display, refill or replace the container with
a full one containing the appropriate pro-
cess chemical at the end of the pro-
gramme.
Confirm the message shown with the

OK button.
36
Replace the container in good time to
prevent the dispensing system being
emptied completely.
Vent an empty dispensing system before
starting the next programme.
Place the container on the open dish-

washer door or on a surface which is easy
to clean.
Take the lid off the canister and remove

the siphon. Place the siphon on the open
dishwasher door.
Fill or replace the container, fit the siphon

and secure the lid. Observe the colour
coding.
Feed the siphon into the canister until it

reaches the bottom.
Wipe up any spilled process chemical

thoroughly.
Place the container on the floor beside the

K
commercial dishwasher or in an adjacent
cabinet. The container must be at the
same level as the machine and not be
OK
placed on top of or above the machine.
The dispensing system must then be ven-

ted.