Product Description; Battery Information - LEXIBOOK RP500TS Mode D'emploi

1. MODE button: Selects the setting mode.
2. SCAN button: Search the radio frequency to find radio channels.
3. RADIO OFF / ON / VOLUME knob: Roll the knob to turn the radio on or off and
increase or decrease the volume.
4. RESET button: Resets the radio frequency so you can start scanning for
channels from the beginning.
5. LCD screen
6. Battery compartment (at the bottom of the unit)
7. Night-light rubber feet
8. SET button: Selects a setting.
9. ADJUST button: Changes the number and activates the snooze function.
10. Buzz Lightyear button
11. Speaker
12. Projector
13. PROJECT button: Projects the time and a Toy Story icon onto the ceiling.
Your Toy Story Radio Alarm Clock Projector works with 4 x 1.5V
batteries (not included).
When you use the RP500TS for the first time:
1. Using a screwdriver, open the battery compartment
cover located at the bottom of the unit.
2. Install the 4 x LR6/AA 1.5V
observing the polarity markings inside the battery
compartment.
3. Close the battery compartment and tighten the screw.
IMPORTANT NOTE: For better performance, it is recommended to use alkaline
batteries with this product.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries
are to be removed from the product before being charged. Rechargeable
batteries are only to be charged under adult supervision. Different types of
batteries or new and used batteries are not to be mixed. Only batteries of the
same or equivalent type as recommended are to be used. Batteries are to be
inserted with the correct polarity. Exhausted batteries are to be removed from
the product. The supply terminals are not to be short circuited. Do not throw
batteries into a fire. Remove the batteries if you are not going to use the
product for a long period of time.
RP500TSIM.indd 8

Product description

Battery information

batteries (not included)
8
AA / LR6 type
1.5V AA OR LR6
1.5V AA OR LR6
1.5V AA OR LR6
1.5V AA OR LR6
03/06/2010 2:36