Safety Installations; Thermal Overload Protection - BDS Maschinen MAB 525 Mode D'emploi

Safety installations

Restarting protection
Magnet indicator

Thermal overload protection

MAB 525
NOTE
► The machine stops automatically of the magnetic clamp is
switched off or in the event of a power failure.
In order to prevent unexpected starting of the machine when the
magnetic clamp is switched on again or when the power supply
returns after a power failure ("restarting protection"), the machine
must be switched on at the ON/OFF switch again.
The magnet indicator provides a visual control of the magnet's
clamping force.
■ Magnet indicator is lit
The magnet's clamping force satisfies the minimum require-
ments. Machining can be carried out.
■ Magnet indicator is lit
Insufficient magnet clamping force. Machining must not be
carried out with the machine. This can be the case in the event
of insufficient material thickness, uneven surface or due to
paint, scale or zinc coatings.
The machine is additionally equipped with thermal overload pro-
tection. If the machine becomes too hot, it switches off automati-
cally.
Carry out the following steps before continuing to work with the
machine:
Remove any blockages that may have occurred.
‹
Allow the machine to run at no-load speed for approx. 2
‹
minutes.
The machine is then ready for operation again.
GREEN:
RED:
Safety
41