Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
26 www.electrolux.com
6.3 Water hardness and
conductivity
Water hardness is different for different lo-
cations. Water hardness has an effect on
the water conductivity and on the con-
ductivity sensor of the appliance. If you
know, the value of the water conductivity
you can adjust the sensor in order to have
better drying results.
Adjusting the conductivity sensor
1. Press the on/off button to activate the
appliance
2. Press and hold touchpads (A) and (B)
at the same time until one of the these
indicators comes on:
•
•
•
3. Press the touchpad (E) again and
again until the indicator of the correct
level comes on.
4. To confirm the adjustment, press and
hold touchpads (A) and (B) at the
same time for approximately 2 sec-
onds.
6.4 The indicator of the water
container
By default, the indicator of the water con-
tainer is on. It comes on when the pro-
7. DAILY USE
Before you use the appliance for
the first time do one of these op-
erations:
• Clean the tumble dryer drum
• Start a short programme (e.g.
At the beginning of drying cycle
(3-5 min.) there could be a slightly
higher sound level. It is because of
start of the compressor that is
normal for compressor powered
appliances such: refrigerators,
freezers .
(low <300 μS/cm)
(moderate 300-600 μS/cm)
(high >600 μS/cm)
with a moist cloth.
30 minutes) with moist laundry.
gramme is completed or when it is neces-
sary to empty the water container.
If the "Draining kit" is installed, the
appliance automatically drains the
water from the water container. In
this condition we recommend that
you deactivate the indicator of the
water container.
Refer to the supplied leaflet for
available accessories.
Deactivating the water container
indicator
1. Press the on/off button to activate the
appliance
2. Press and hold touchpads (J) and (I)
at the same time until the display
shows one of these 2 configurations:
• The indicator
cator
– The indicator of the water con-
tainer is off. After approximately 4
seconds, the 2 indicators go off .
• The indicators
on.
– The indicator of the water con-
tainer is on. After approximately 4
seconds, the 2 indicators go off
7.1 Starting a programme
without delay start
1. Prepare the laundry and load the ap-
pliance.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and op-
tions for the type of load.
• The display shows the programme
duration.
4. Press the Start/Pause touchpad, the
programme starts.
is off and the indi-
is on.
and
are
Publicité
Chapitres
Table des Matières
