Safety Devices; Cleaning And Maintenance - Domo DO7345H Mode D'emploi

TEMPERATURE
1. Press this button to set the temperature.
2. Temperature can be set between 15°C and 35°C. Use the + and - button to select the desired
temperature. By pressing the + or - button you set the temperature one degree higher or lower. You
can also press and hold this button until you reach the desired setting.
The configurations will automatically be saved after a few seconds if you no longer touch the + or –
button.
Note: if both the timer and temperature are set, both settings will appear alternately on the display.

SAFETY DEVICES

· This heater is protected with an overheat protection that switches off the heater automatically in case
of overheat, e.g. due to the total or partial obstruction of the grids. The overheating shut-off switches
off the temperature inside when the appliance exceeds the normal running temperature. The heating
element will automatically stop working, the motor will continue to operate, the internal heat shed.
This protective device applies only to the appliance itself and has no influence on room temperature
regulation. In this case, unplug the appliance, wait about 10 minutes for it to cool and remove the
object that is obstructing the grids. Then switch it back on as described above. The appliance should
operate normally. Should the problem persist, please contact the nearest customer service.
· The appliance is also equipped with a tip-over safety, which is integrated in the appliance. The
appliance will turn off when it tips over.
ERRORS
· EE: the temperature of the appliance is too high, it is also impossible to set the temperature now. Let
the appliance cool down before setting the temperature.
· LO: the ambient temperature is lower than -10°C. Make sure the appliance is in a warmer
environment.
· HI: the ambient temperature is higher than 40°C. Make sure the appliance is in a colder environment.

CLEANING AND MAINTENANCE

· Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down
completely.
· To avoid the risk of electric shock, do not clean the heater with water and do not immerse it. Clean the
housing with a damp cloth.
· If necessary, dust particles accumulated in the air outlet openings may be removed with a vacuum
cleaner. This maintenance should be done regularly to assure the good operation of the appliance.
Dust particles in the appliance may cause over-heating.
· Store the appliance in a clean and dry place.
28
DO7345H