Liquid Vacuum Operation - ArmorAll AA255 Manuel D'utilisation

LIQUID VACUUM OPERATION

1
6
LIQUID VACUUMING
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY, INFORMATION, ENTITLED 'IMPORTANT SAFETY
INSTRUCTIONS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN
THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR GUN POWDER. TO REDUCE THE RISK
OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT
VACUUM TOXIC MATERIALS.
WARNING:
MAKE SURE PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Remove reusable cloth filter, then carefully install the foam wet filter over the filter cage and place the power head
back on the collection tank. (fig. 2, 3 & 4) For filter installation instructions, see page 10.
DO NOT USE THE REUSABLE CLOTH FILTER FOR LIQUID VACUUMING.
OPERATING INSTRUCTIONS: WET VACUUMING
3. Fit the desired nozzle to the vacuum hose. (fig. 5)
4. Verify that the switch is in the 'O' OFF position before plugging the power cord into the outlet. (fig. 6)
5. Turn the motor on by flipping the switch to the 'I' ON position. (fig. 7)
6. After use, empty the collection tank. Clean and dry the inside and outside before storage.
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely in the liquid; leave a
gap at the tip of the nozzle opening to allow air inflow. The machine is fitted with a float valve that stops the suction action
when the collection tank reaches its maximum capacity. You will notice an increase in motor speed. When this happens,
turn off the machine, disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue
vacuuming, refit the power head to the collection tank. After wet vacuuming, turn the machine off and remove plug from
power supply. Empty the collection tank. Clean and dry the inside and outside before storage. REMEMBER! The foam
filter must be removed after wet vacuuming, and a reusable cloth filter must be installed before dry vacuuming again.
2 3
7
4
8
5