Installation Methods - Kenwood KS-3200HT Mode D'emploi

Installation Methods

On the Desktop or Shelf
Place the speakers on the desktop, shelf or a similar level surface.
The KS-5200HT and KS-5200EX are supplied with the speaker stands for the front speakers. Refer to the separate instruction
manual for the speaker stands when installing the speakers using the stands.
On the Wall
The speakers include mount holes for wall mounting. You can hang the front and surround speakers on the wall vertically, and the
center speaker horizontally.
7 Front speaker , Surround speaker
1. Screw a single screw into the wall at the desired loca-
tion. Screw it only part way in, so that the screw projects
8 to 10 mm (5/16 to 3/8 inches) outward from the wall
surface.
2. Hang the speaker by fitting the top mount hole (at the
upper rear of the speaker) over the extending part of
the screw. Confirm that the speaker is held firmly and
securely in place.
7 Center speaker
1. Screw two screws into the walls 150 mm (5-7/8 inches)
apart, making sure that screws are horizontally level.
Screw each screw only part way in, so that the screw
projects 8 to 10 mm (5/16 to 3/8 inches) outward from
the wall surface.
2. Hang the speaker by fitting the two mount holes (at the
rear of the speaker) over the extending part of the screw.
Confirm that the speaker is held firmly and securely in
place.
Precautions
Please observe the following precautions when mounting speakers onto the wall.
• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. front speaker : 0.8 kg
[1.8 lb], center speaker : 0.8 kg [1.8 lb], surround speaker : 0.6 kg [1.3 lb]).
• Wall screws must be purchased separately. Be sure to use screws that are appropriate for the wall you are using, and that
are long enough to provide sufficient strength.
• If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of
installation, please consult a contractor or other qualified person before proceeding.
Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury
or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient
support strength.
Various mounting methods
7 On the optional kenwood stand (SR-8000)
(front speaker and surround speaker only)
The speaker can be installed on the SR-8000 stand optionally
available from KENWOOD.
7 On the commercially available speaker mount or bracket
(front speaker only)
Any commercially available speaker mount or bracket can also
be used (provided that the speaker can be fixed using an M5
screw with a pitch of 60 mm and
effective thread length of 10 to 13
mm).
For details, read the instruction
manual for the speaker mount or
bracket.
4
EN
150 mm
(5-7/8")
Attaching the cushions
Attach cushions to the base of the speaker as shown below.
The cushions prevent the speaker from sliding, and dampen
its vibrations.
Front speaker,
Surround speaker
E ffe c t i ve t h r e a d
length
M5 screw
8 - 10 mm
(5/16 - 3/8")
8 - 10 mm
(5/16 - 3/8")
Center speaker