Handling Fuel - RedMax BCZ2401S Mode D'emploi

Masquer les pouces Voir aussi pour BCZ2401S:
Table des Matières

Publicité

16
English
5. For safe operation
manual must be performed, please contact a
representative from the store nearest RedMax
authorized servicing dealer for assistance.
5. Do not use any accessory or attachment other than
those bearing the RedMax mark and recommended
for the unit.
6. Under no circumstances should you ever take apart
the product or alter it in any way. Doing so might
result in the product becoming damaged during
operation or the product becoming unable to operate
properly.

■ HANDLING FUEL

1. The engine of the RedMax product is designed to
run on a mixed fuel which contains highly flammable
gasoline. Never store cans of fuel or refill the tank of
the unit in any place where there is a boiler, stove,
wood fire, electrical sparks, welding sparks, or any
other source of heat or fire which might ignite the
fuel.
2. Never smoke while operating the unit or refilling its
fuel tank.
3. When refilling the tank, always turn off the engine
and allow it to cool down. Take a careful look around
to make sure that there are no sparks or open
flames anywhere nearby before refueling.
(1) Refill after cooling the engine
4. Wipe spilled fuel completely using a dry rag if any
fuel spillage occurs during refueling.
5. After refueling, screw the fuel cap back tightly onto
the fuel tank and then carry the unit to a spot 10feet
(3m) or more away from where it was refueled
before turning on the engine.
■ TRANSPORTATION
1. When hand-carrying the product, cover over the
cutting part if necessary, lift up the product and carry
it paying attention to the blade.
2. Never transport the product over rough roads over
long distances by vehicle without removing all fuel
from the fuel tank. If doing so, fuel might leak from
the tank during transport.

Publicité

Table des Matières
loading

Table des Matières