EarthQuake BADGER 20908 Manuel De L'utilisateur page 11

FIGURE 3
Tine Shield
FIGURE 4
FIGURE 5
FIGURE 6
For additional information visit online at www.getearthquake.com or call 800-345-6007 M-F 8-5 CST
Hairpin
Washer
Lower Tail
Mount
Wheel
Engine
Mount Deck
Dirt
Shield
Narrow
Tine
Width
Wide Tine
Width
7. a. Assemble the upper handle bar assembly onto the
lower loop mount using four M8 bolts, four M8 flat
washers and four M8 locknuts. The handlebar as well as
the bolt should go on the outer side of the lower loop
mount, while the washer and nut should be placed on
the inside. SEE FIGURES 7 & 8
b. The upper two bolts can be assembled through one of
three hole positions depending on the user's preferred
handle bar height (low, middle, high). For the highest
height, insert bolt into the most forward hole. For the
lowest height, insert bolt into the most rear hole. SEE
FIGURE 7
8. Insert depth regulator/drag stake through bottom opening
in lower tail mount and secure with lock pin. SEE FIGURE 9
Lower Loop Mount
FIGURE 8
FIGURE 9
Operator's Manual
BADGER Front Tine Tiller
High
Position
Medium
Position
Low
Position
Upper Bolt
Lower Bolt
Nylock
Nut
Drag Stake
FIGURE 7
Lock
Pin
11