SOMFY Wisniowski Metro 800 RTS Manuel D'utilisation page 10

EN
When disengaging the motor drive mechanism, use caution for a
badly balanced door may cause sudden door movement that may
be dangerous.
Only use the cord to disengage the motor drive mechanism. Never
use the cord to move the door manually.
Always reengage the motor drive mechanism before sending
another command to the motor drive unit.
4.2
Depending on the peripherals installed and the operating options set by your
installer, the motorisation may perform the following special operations:
An obstacle detected between the cells will prevent the door from closing.
The door will stop and then completely or partially reopen (depending on the
setup selected during installation) when an obstacle is detected during the
close cycle.
Opening a pedestrian door within the garage door will prevent the door from
moving.
A two second delay before the door starts to move can be selected during
installation.
Remote lighting operation
The light comes on every time the motor drive unit is operated. The light will go
out one minute after the door stops moving. The time delay can be adjusted
during installation.
If a remote control button is programmed for remote lighting, it works as
illustrated as below.
The door is automatically closed after a time delay set at the time of installation.
An additional command during this time will cancel the automatic closure and
the door will remain open.
4
If a back-up battery is installed, the Metro motor will operate when a power cut
occurs.
The following conditions apply to operation:
- Door speed is reduced.
- The light will not come on.
- The safety devices are disabled.
- Endurance: The battery will last for 24 hours with a maximum of 5 to 10
operating cycles depending on the weight of the door.
- Recharging time: 48 hours.
- Service life prior to replacement: approx. three years.
To ensure optimum battery life, we recommend that the power to the motor is
switched off and the door is operated for a number of cycles using
battery power (three times a year).
This function makes it possible to manipulate the door at any moment (loss of
remote control, photoelectric cell fault, etc.).
Remove the integrated light cover to access the "+" and "-" buttons.
Door stationary:
press the "-" button to close it
press the "+" button to open it.
Door moving: press the "-" or "+" button to stop the door.
Detection of forced entry starts operating 30 seconds after the door is closed.
If forced entry is detected, the siren will sound for 2 minutes, the light integrated
a button on a memorised remote control.
4.3
A
5 -
5.1
The LCD display is situated under the lighting cover. It provides motor operation
status.
The main operating codes are as follows:
Waiting for a command
Door opening
Waiting for the door to
close
Door closing
Obstacle detection
Metro 800 RTS / Metro 1000 RTS
2s
B
A
Indicates that the door encountered an
obstacle. The display is maintained for
30 s after detection.
Copyright © 2016 Somfy SAS. All rights reserved