Cycle Changes; Delayed Start Setup; Use Instructions - Tecno-gaz MultiSteril Mode D'emploi

ENGLISH
7.5

Cycle changes

Select the cycle to be modified.
OK
Press to display the MENU.
Available parameters:
Description
Standby
Detergent infeed
Heating
Degas function
SWEEP function
Ultrasound cleaning
Drying
OK
Press to scroll the cycle parameters.
SELECT
Press to modify the value of the selected parameter.
The menu of the parameters and setup scrolls circularly.
Once the setup is completed select EXIT and press
Changes are saved.
7.6

DELAYED START setup:

START
Hold down
SELECT
Press to scroll values from 1 to 9 hours.
START
Press to start the delayed start.
During the waiting time a timer is displayed showing the time remaining before the cycle
start.
WARNING: In case voltage is missing the delayed start is cancelled.
8
Open the water feeding cock. Check the presence of the filter in the tank and make sure it
is clean. Position the item to be cleaned into the TRAY in case of small parts use the
DENTAL BURS TRAY.
Items to be cleaned have to be distributed uniformly and must not touch the tank walls or
bottom.
Fit the tray inside the tank, be sure there is no contact between the tank walls and
the tray.
Cements, alginates, and composites must be treated with specific fluids.
16
for 8 seconds.

USE INSTRUCTIONS

Parameters
ON - OFF
0 ÷ 6 %
ON - OFF
SI - NO
SI - NO
0 ÷ 30 min
SI - NO
SELECT
to quit the MENU.
CARICO MASSIMO
Step
-
1%
-
-
-
1 min
-
LIVELLO DI