Filling Of The Detergent Reservoir - Tecno-gaz MultiSteril Mode D'emploi

ENGLISH
Check the integrity of the power cord.
Connect the power cord to the socket on the rear side of the appliance (M).
Do not use extensions, reductions or adapters for connection
Switch on the device through the switch (L) .
Open the water feeding cock and make sure the feeding hose has no leak (if leaks are
present, clamp couplers and make sure gaskets are fitted). Make sure the tank filter is
present and that it is clean.
Check of correct drain
The appliance On, inject 1 liter of water into the tank and make sure the drain takes about
1 min.
6.2

Filling of the detergent reservoir:

The tank has a capacity of about 2 l , o.5 of which as reserve.
During the filling the device has to be ON and display 'CYCLE SELECTION.
ALWAYS SWITCH ON THE DEVICE BEFORE FILLING THE DETERGENT
10
Power cord
TANK
Open the tank lid and lift the cap (V) on the left side of the
tank.
Feed the detergent (use the funnel coming with the
appliance) until and acoustic/visual signal (on the display)
warns that the reservoir is full