Weber SUMMIT S-670 Guide De L'utilisateur page 24

Masquer les pouces Voir aussi pour SUMMIT S-670:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

24
PROBLEM
Burners burn with a yellow or orange flame, in
conjunction with the smell of gas (This is normal
for the burner lighting tube).
Symptoms:
Burner does not light, or flame is low in "HI"
position.
Experiencing flare-ups:
CAUTION: Do not line the bottom tray
with aluminum foil.
Burner flame pattern is erratic. Flame is low when
burner is on "HI". Flames do not run the whole
length of the burner tube.
Inside of lid appears to be "peeling." (Resembles
paint peeling.)
Cabinet doors are not aligned.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com
®
.
PROBLEM
Side Burner does not light.
Flame is low in "HI" position
Push button ignition does not work.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
®
site. Log onto www.weber.com
.
TROUBLESHOOTING
CHECK
Inspect Spider/Insect Screens for possible obstructions.
(Blockage of holes.)
Is fuel hose bent or kinked?
Does Burner light with a match?
Did you use the snap igniter several times until the main
burner lit (See Lighting Instructions)?
Does the igniter work (Do you see a spark when you
repeatedly use the snap igniter?
Are you preheating barbecue in the prescribed manner?
Are the cooking grates and Flavorizer
coated with burned-on grease?
Is the bottom tray "dirty" and not allowing grease to flow
into catch pan?
Are burners clean?
The lid is porcelain enamel or stainless steel, not paint. It
cannot "peel". What you are seeing is baked on grease
that has turned to carbon and is flaking off.
THIS IS NOT A DEFECT.
Check the adjustment pin on the bottom of each door.
SIDE BURNER TROUBLESHOOTING
CHECK
Is gas supply off?
Is the fuel hose bent or kinked?
Does burner light with a match?
Clean Spider/Insect Screens. (See Section "Annual
Maintenance")
Straighten fuel hose.
If you can light Burner with a match, then check the
®
Crossover
ignition system.
Make sure to hold the control knob in for two seconds after
snapping the igniter and seeing the orange flame from the
burner lighting tube.
Try manually lighting the burner (refer to "Main Burner
Manual Lighting"). Call customer service.
All burners on HI for 10 to 15 minutes for preheating.
®
bars heavily
Clean thoroughly. (See Section "Cleaning")
Clean bottom tray.
Clean burners. (See Section "Maintenance".)
Clean thoroughly. (See Section "Cleaning".)
Loosen adjustment nut/s. Slide door/s until aligned. Tighten
nut.
Turn supply on.
Straighten hose.
If match lights burner, check igniter (see below).
CURE
CURE
WWW.WEBER.COM
®

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

89208

Table des Matières