Jenn-Air 8112P212-60 Guide De L'utilisateur page 6

O C
VEN OOKING
Entering the day of the week:
1. Press Setup pad.
2. Select Clock.
3. Select Day.
4. Select Back or Fwd to scroll through the days.
5. Select Set.
6. To exit the Setup mode, press Setup.
Canceling the clock/day of week display:
1. Press Setup pad.
2. Press Clock.
3. Press the Down arrow to scroll to the next screen.
4. Select Disable.
5. Select Off to turn the clock display off, or select On to turn
the clock display on.
6. Select Set.
7. To disable the day of week display, select OFF or select ON
to turn the weekday display on.
8. Select Set.
9. To exit the Setup mode, press Setup.
To set the clock for a 12 or 24 hour format:
The clock can be set to display time in either a 12 hour or 24
hour format.
1. Press the Setup pad.
2. Select Clock.
3. Use the down arrow to scroll to the next screen.
4. Select 12/24 Hr.
5. Select 12 Hr or 24 Hr.
6. Select Set.
7. Press Setup to exit Setup mode.
Timers
Setting the Timers (Timer 1 or Timer 2):
1. Press Timer 1 or Timer 2.
2. Select Time.
3. Press one of the displayed times using the Quickset pads,
or press the number pads to enter the desired time.
Note: Each press of the displayed time choices adds
additional time. For example, pressing "10 min" three times
provides 30 minutes on the timer (0:30).
4. Press Enter.
Changing the amount of time entered once the
Timer starts:
1. Press the Timer 1 or Timer 2 pad ONCE.
2. Press the displayed times on the Quickset
pads until the desired time is entered.
OR
3. Press the number pads to enter the new desired time.
4. Press Enter.
Canceling the Timer:
1. Press the Timer 1 or Timer 2 pad TWICE.
OR
2. Press the Timer 1 or Timer 2 pad ONCE and
Press CANCEL on the Quickset pads.
Changing the Timer format:
The Timers can be set to display hours and minutes (HR/MN)
or minutes and seconds (MN/SEC).
1. Press the Setup pad.
2. Select the Down arrow and
scroll until you see Timer Format.
3. Select Timer Format.
4. Select HR/MN or MN/SEC.
5. Select Set.
6. Press Setup to exit Setup mode.
Changing the Timer beeps:
The signal beeps for Timer 1 and Timer 2 can be changed.
The options available are two beeps every thirty seconds, two
beeps every sixty seconds or 1 beep only. The default setting
is One Beep.
1. Press the Setup pad.
2. Select the down
arrow to scroll down until "Tones" is displayed.
3. Select Tones.
4. Select Timers.
5. Select the desired timer beep format (2-30 sec., 2-60 sec.
or 1 Beep).
6. Select Set.
7. Press Setup to exit Setup mode.
5